Your heating boiler economy is affected by where you are

Manufacturers have made multiple products and services that you can add to your central heating system to help it to perform efficiently for a longer period of time. The point being that if you look after your system it will look after you. Environmental agencies and local authorities constantly advise us to economise our carbon footprint by switching off unneeded lights and electric devices and by setting our thermostats at lower temperatures. These environmentally conscious steps not only save the greenery on our planet, but also save the pound notes in our wallet. Are you paying the same attention to your central heating system? The heating system is also prone to reduced efficiency caused by corrosion, limescale formation and gunk buildup.

You should be thinking about water treatment to stop this accumulation of gunk and limescale, especially if you live in a hard water area.

Water treatment looks after your system in more than one way. A wide assortment of water treatment products is easily available like sludge remover, scale reducer, anti-freeze, magnetic scale fighter, noise reducer, electronic scale inhibitor, and the like.

In the UK, depending on where you live, your water could range between hard and soft. If you spot limescale formation inside your kettle or bath taps, there is probably hard water running in your taps. These deposits decrease the efficiency of your system which in turn increases your household bills. The energy cost in a boiler cylinder with limescale lining can be 40 percent more than a clean boiler leading to more expensive gas bills. Limescale is simply calcium deposits in your system. These problems are not seen in areas that get soft water, however in case of any doubt one should always seek advice.

The way that most water treatments work is by changing the molecular structure of the water’s particles which, in turn alters the way it behaves. Water treatment works in different ways, it can change the structure or prevent the formation of solid or remove the offending particle altogether.

You can find out the ph and chloride, iron and copper levels with chemical test kits, which will allow you to measure the likely corrosion rate in your system.

Your system must be installed by a professional, never connect brass or copper to aluminum as this can lead to corrosion through the interaction of these metals. All gas connections must be made by a CORGI registered tradesperson.

You should decide about the water treatment well in advance, especially when you are installing a new heating system. If you are upgrading your current system, you must cleanse your whole system before any water treatment chemicals are added.

The mains water supply provides water to the heating systems, one can fix various other systems with the mains supply in order to deal with the problem of hard water, however these systems that soften the water work only for your household, they don’t do much about the problems associated with the central heating system. These water softening chemicals can produce better lather and are good for your skin, but they cannot reverse the choking and pitting inside the heating system.

With regards to heating systems, you have to prevent three important things viz,limescale, corrosion and biological growth.

Right from the time the system is installed and commissioned, internal conditions can cause corrosion to set in. Corrosion causes gunk in the system which can restrict the circulation causing cold spots on your radiators. It can cause pinholes in the radiators and if left can cause the boiler to become noisy.

Limescale is caused by calcium and magnesium which is present in the water hard water areas having far more of these minerals than other parts of the country. When the water is heated, these minerals deposit, forming a hard crust that grows with time and blocks the pipes. This again can manifest itself with a noisy heating system.

Biological growth is another thing that should be avoided at all costs. This is usually introduced into the system through open tanks. It establishes itself in the system and then produces sludge and slime. This material can really make your system under perform by clogging up the pipework.

You can learn more about these problems on the internet. Take some time to look through this. We recommend starting with the manufacturers themselves. Browse through some of the reputed water treatment companies and their acclaimed products on this page. Blogs are another great source of free advice and information or contact a supplier with any queries that you may have.

Good luck with your water treatment heres to energy cost-efficient heating and hot water with lower household bills of course.